Transistor Tester
I found this nice project, that can serve as a great tool in my workshop. The circuit was complicated and could not be made on perf board, well it could be but it’d …
I found this nice project, that can serve as a great tool in my workshop. The circuit was complicated and could not be made on perf board, well it could be but it’d …
Store an image in an audio file, this is done by the use of wavelets. Here is the research paper. New to Wavelets, here is the best tutorial IMHO The audio file is in WAV …
I had two 8x8 LED matrix lying around and a tiny2313, hoping one day I’d experiment with them, I came across a project, and it was a great start. This is what I …
I made a laptop stand made out of a strip of mdf and two supports, it basically lifts the laptop a bit so as to give it some room the breathe, I have a small fan that …
I made this for my nephew on his 10th birthday All the details of the project are here the controller is atmega8 running on inter 8Mhz with arduino boot loader.
Finally after days of tinkering finally got mega8 running on internal oscillator with arduino bootloader. I use arduino in most of my projects as it has amazing code base …
\# Fuse atmega8 high byte HFUSE: # 0xc9 = 1 1 0 0 1 0 0 1 <-- BOOTRST (boot reset vector at 0x0000) # ^ ^ ^ ^ ^ ^ ^------ BOOTSZ0 # | | | | | +-------- BOOTSZ1 # | | | …
On the quest to make my own oscilloscope and logic analyser using KST Planning to make a gui that will read the serial port and log the data to file that will be read by …
This is a nice little nifty circuit that has a power jack, 7805 regulator ,two capacitors and connector. It send the input power to upper rails and 5v to lower rails, …
I always wanted to make a clock, I have many instrustables bookmarks I finally settled on one, the binary, built on arduino, and not special rtc, just good ol’ …